Montero V6-3.8L SOHC (2005)
2. Measure the resistance value between terminal 5 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 10.
NO: Go to Step 9.
STEP 9. Check the wiring harness between sunroof motor assembly connector F-02 (terminal 5) and ground.
Q: Is the wiring harness between sunroof motor assembly connector F-02 (terminal 5) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The system should communicate with the sunroof motor assembly (sunroof-ECU) normally.
STEP 10. Check ETACS-ECU connector D-224 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector D-224 in good condition?
YES: Go to Step 11.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The system should communicate with the sunroof motor
assembly (sunroof-ECU) normally.