Montero V6-3.8L SOHC (2005)
Q: Is sunroof motor assembly connector F-02 in good condition?
YES: Go to Step 2.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The sunroof should now work normally.
STEP 2. Check the fusible link (4) line of power supply circuit to the sunroof motor assembly. Test at sunroof motor assembly connector F-02.
1. Disconnect sunroof motor assembly connector F-02 and measure the voltage available at the wiring harness side of the connector.
2. Measure the voltage between terminal 1 and ground.
-
The voltage should be approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 4.
NO: Go to Step 3.
