Montero V6-3.8L SOHC (2005)
STEP 28. Check combination meter connector D-04 and ETACS-ECU connector D-222 for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Are combination meter connector D-04 and ETACS-ECU connector D-222 in good condition?
YES: Go to Step 29.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 29. Check the wiring harness between combination meter connector D-04 (terminal 37) and ETACS-ECU connector D-222 (terminal 14).
NOTE: Also check junction block connector D-210 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If junction
block connector D-210 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between combination meter connector D-04 (terminal 37) and ETACS-ECU connector D-222 (terminal 14) in good condition?