Montero V6-3.8L SOHC (2005)
Q: Are the harness wires between rear wiper motor connector I-07 (terminal 2) and ETACS-ECU connector D-222 (terminal 1) in good condition?
YES: Go to step 7.
NO: The wiring harness may be damaged or the connectors may have loose, corroded or damaged terminals or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the rear wiper works normally.
STEP 7. Check the rear wiper motor.
1. Disconnect the rear wiper motor connector I-07.
2. Connect a battery to the wiper motor as shown in the illustration and inspect the motor operation.
Q: Is the rear wiper motor in good condition?
YES: No action is necessary and testing is complete.
NO: Replace the rear wiper motor. Verify that the rear wiper works normally.
STEP 8. Check the ground circuit to the rear wiper motor. Test at rear wiper motor connector I-07.
1. Disconnect rear wiper motor connector I-07 and measure the resistance available at the harness side of the connector.