Montero V6-3.8L SOHC (2005)
STEP 10. Check the wiring harness between combination meter connector D-03 (terminal 62) and the ignition switch (IG1).
NOTE: Also check junction block connectors D-208 and D-210 for loose, corroded, or damaged terminals, or terminals pushed back in the connector.
If junction block connector D-208 or D-210 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between combination meter connector D-03 (terminal 62) and the ignition switch (IG1) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the seat belt warning light illuminates normally.
