Montero V6-3.8L SOHC (2005)
STEP 6. Check the wiring harness between dome light connector F-03 (terminal 1) and fusible link (1).
NOTE: Also check intermediate connector D-26, D-28, junction block connector D-207 and D-221 for loose, corroded, or damaged terminals, or
terminals pushed back in the connector. If junction block connector D-207, D-221, intermediate connector D-26 or D-28 is damaged, repair or replace
the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between dome light connector F-03 (terminal 1) and fusible link (1) in good condition?
YES: Go to Step 7.
NO: Repair the wiring harness. Verify that the dome light illuminates normally.
STEP 7. Check ETACS-ECU connector D-222 for damage.
Q: ETACS-ECU connector D-222 in good condition?
YES: Go to Step 8.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Verify that the dome light illuminates normally.