mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Relays and Modules - Steering and Suspension > < Seat Belt Control Module|Testing and Inspection|Page 168
Page 2
background image

REMOVAL SERVICE POINT

[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION

DANGER:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

WARNING:  Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.

INSTALLATION SERVICE POINTS

]]A[[ PRE-INSTALLATION INSPECTION

WARNING:  The SRS may not activate if the SRS-ECU is not installed properly, which could result in serious injury or death to the vehicle's
driver or front passenger.

]]B[[ ATTACHMENT OF BRACKET MOUNTING BOLT (GROUNDING BOLT)

Check the head mark "E" on the bolt and attach the grounding bolt.

]]C[[ POST-INSTALLATION INSPECTION 

1. Reconnect the negative (-) battery cable. 
2. Turn the ignition key to the "ON" position. 
3. Does the "SRS" warning light illuminate for approximately seven seconds after turning "OFF?" 
4. If yes, the SRS system is functioning properly. If no, refer to SRS WARNING LIGHT CHECK.

Relays and Modules - Steering and Suspension > < Seat Belt Control Module|Testing and Inspection|Page 168