mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Ignition Switch|Page 3990 > < Ignition Switch|Page 3988
Page 8
background image

1. Remove the driver's side under cover.
2. Remove the column covers, lower and upper.
3. Disconnect wiring connector D-16 from the key reminder switch and measure at the key reminder switch side.

4. Follow the table to measure the resistance between terminal numbers 4 and 6.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 9.

NO: Replace the key reminder switch. Then check that the malfunction is eliminated.

STEP 9. Check the input signal from the key reminder switch.

Check that the tone alarm stops sounding when terminal number 6 is grounded.

Q: Does the tone alarm stop sounding?

YES: Go to Step 10.

NO: Go to Step 12.

Ignition Switch|Page 3990 > < Ignition Switch|Page 3988