Montero Sport V6-35L SOHC (2004) - Ignition Switch Testing
STEP 19. Check the harness wire between ETACS-ECU connector D-11 (terminal No.5) and column switch.
NOTE: After checking junction block connector D-01 and joint connector (3) C-72, check the wires. If junction block connector D-01 and joint
connector (3) C-72 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Is the harness wire between ETACS-ECU connector D-11 (terminal No.5) and column switch?
YES: Go to Step 20.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 20. Check for continuity between terminals (except No. 4 and No. 6) of key reminder switch connector D-16.
1. Measure at key reminder switch connector D-16 without disconnecting the connector.
2. Check that there is no continuity between key reminder switch terminal No. 4 and each terminal (except terminal No. 6), as well as between key
reminder switch terminal No.6 and each terminal (except terminal No. 4).
Q: Does continuity exist between terminals?