Montero Sport V6-3.5L SOHC (2004)
STEP 6. Check the harness wire between daytime running light-ECU connector A-96 (terminal No.2) and ignition switch.
NOTE: After checking junction block connector D-01 and D-08, check the wires. If junction block connector D-01 and D-08 are damaged, repair or
replace them. Refer to Harness Connector Inspection.
Q: Are the harness wire between daytime running light-ECU connector A-96 (terminal No.2) and ignition switch in good condition?
YES: Go to Step 7.
NO: Repair or replace the damaged components. Refer to Harness Connector Inspection.
STEP 7. Check the daytime running light ground circuit at daytime running light connector A-96.
1. Disconnect daytime running light connector A-96.
2. Measure the resistance between terminal 6 and ground.
Q: Is resistance between terminal 6 and ground less than 2 Ohms?