mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Relays and Modules - Starting and Charging > < Seat Belt Control Module|Testing and Inspection|Page 190
Page 2
background image

Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and deployment.

INSTALLATION SERVICE POINTS

]]A[[ SRS-ECU INSPECTION

WARNING:  The SRS may not active if the SRS-ECU is not installed properly, which could result in serious injury or death to the vehicle's
driver or front passenger.

]]B[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.

3. Does the "SRS" warning light illuminate for approximately 7 seconds, and then remain off for at least 5 seconds after turning "OFF?"
4. If yes, the SRS system is functioning properly.

If no, consult DTC 46 Improper installation of SRS-ECU.

Relays and Modules - Starting and Charging > < Seat Belt Control Module|Testing and Inspection|Page 190