mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Air Bag Control Module > < Air Bag Systems|Testing and Inspection|Page 3317
Page 5
background image

Turn the clock spring clockwise fully. Then turn it back approximately 3 4/5 turns counterclockwise to align the mating marks.

]]C[[ STEERING WHEEL INSTALLATION

CAUTION:  When installing the steering wheel, ensure that the harness of the clock spring does not become caught or tangled.

1. Before installing the steering wheel, turn the vehicle's front wheels to the straight-ahead position and align the mating marks of the clock spring.
2. After securing the steering wheel, turn the steering wheel all the way in both directions to confirm that the steering wheel rotation is normal.

]]D[[ AIR BAG MODULE INSTALLATION (DRIVER'S SIDE)

1. Connect the air bag module connector securely.

2. Tighten the air bag module mounting screws to 8.8 Nm (78 in-lb).

]]E[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately 7 seconds, and the remain off for at least 5 seconds after turning "OFF?"
4. If yes, the SRS system is functioning properly.

If no, consult DTC 46 Improper installation of SRS-ECU.

Air Bag Control Module > < Air Bag Systems|Testing and Inspection|Page 3317