Montero Sport V6-3.5L SOHC (2004)
Data List
4. Erase DTC's and after waiting 5 seconds or more read (and write down) all displayed DTC's. (Refer to Inspection chart for DTC's.) See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions/Supplemental Restraint
System (SRS)
REPAIR PROCEDURE
WHEN AIR BAGS DEPLOYS IN A COLLISION.
1. Replace the following parts with new ones.
-
Front impact sensors
-
SRS-ECU
-
Air bag module
-
Seat belt pre-tensioner
2. Check the following parts and replace if there are any malfunctions.
-
Clock spring
-
Steering wheel, steering column and intermediate joint
1. Check the wiring harness (built into the steering wheel) and connectors for damage, and terminals for deformation.
2. Install the air bag module to check fit or alignment with the steering wheel.
3. Check the steering wheel for noise, binds or difficult operation and excessive free play.
4. Check the steering column shaft shock absorbing mechanism (Refer to On-Vehicle Service - Steering Column Shaft Assembly Shock
Absorbing Mechanism Check).
3. Check the wiring harnesses for binding, the connectors for damage, poor connections, and the terminals for deformation. (Refer to SRS SERVICE
PRECAUTIONS.)
WHEN AIR BAG DOES NOT DEPLOY IN LOW-SPEED COLLISION.
Check the SRS components. If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.
Concerning parts removed for inspection, replacement with new parts and cautionary points for working, refer to the appropriate INDIVIDUAL
COMPONENT SERVICE.
Front impact sensors
1. Check the fender shield panel for deformation or rust.
2. Check the front impact sensor for dents, cracks, deformation or rust.
3. Check the sensor harnesses for binding, the connectors for damage, and the terminals for deformation.
SRS-ECU
