Montero Sport V6-3.5L SOHC (2004)
1. Check the identification marks at the end of the left and right torsion bars.
R -> for right side
L -> for left side
2. When installing the torsion bar, align the white mark on the serrated section of the torsion bar with the mating mark on the anchor arm.
3. Mount the anchor bolt as shown in the illustration, and install the rear anchor arm adjusting nut.
>>B<< BUMP STOPPER AND BUMP STOPPER BRACKET CLEARANCE ADJUSTMENT
1. With the vehicle in an unladen condition, dimension A from the bump stopper to the bump stopper bracket should be 18 - 20 mm (0.71 - 0.79
inch).
NOTE: Dimension A will be 18 mm (0.71 inch) (B = 50 mm [2.0 inches]) when the bump stopper is a new p0art. When the bump stopper is
worn and becomes less than 50 mm (2.0 inches), dimension A will increase by the decreased amount.
2. If dimension A is not 18 - 20 mm (0.71 - 0.79 inch), adjust the anchor arm assembly adjusting nut.
INSPECTION
LOWER ARM BALL JOINT END PLAY
Check the lower arm ball joint assembly end play by following the steps.