Montero Sport 2WD V6-3.0L SOHC (1997)
Hydraulic Assembly: Service and Repair
Hydraulic Unit
1. Drain the brake fluid.
2. Remove the brake lines.
3. Remove the harness connector. Turn the lock lever in the direction shown in the illustration, and remove the harness.
4. Remove the bracket assembly and then the Hydraulic Unit (HU).
CAUTION:
-
The hydraulic unit is heavy. Use care when removing it
-
The hydraulic unit cannot be disassembled. Never loosen its nuts or bolts.
-
Do not drop or shock the hydraulic unit.
-
Do not turn the hydraulic unit upside down or lay it on its side.
5. Reverse procedure to install, noting the following:
-
Bleed the brake lines of air and connect the tubes to the hydraulic unit as shown in the illustration.