Montero Sport 2WD V6-3.0L SOHC (1997)
1. Install the throttle position sensor to the throttle body as shown in the illustration.
2. Turn the throttle position sensor 90° counterclockwise to set it and tighten the screws.
3. Connect an ohmmeter between terminals 1 (ground) and 3 (output) or between terminals 3 (output) and 4 (power). Then, make sure that the
resistance changes smoothly when the throttle valve is slowly moved to the fully open position.
4. Check for the continuity between terminals 2 (closed throttle position switch) and 1 (ground) with the throttle valve both fully closed and fully
open.
If there is no continuity with throttle valve fully closed, turn the throttle position sensor clockwise and then check again.
5. If the above specifications are not met, replace TPS.
