Montero Sport 2WD V6-3.0L SOHC (1997)
Throttle Position Sensor: Adjustments
Required Speed Tools:
MB991502: Scan Tool
MB991348: Test Harness Set
Procedure
1. Connect the scan tool to the data link connector. When not using scan tool, MB991502, proceed as follows.
(1) Disconnect the connector of the throttle position sensor.
(2) Connect an ohmmeter between terminals 2 (closed throttle position switch) and 1 (sensor ground) by using jumper wires.
2. Insert a feeler gauge with a thickness of 0.65 mm (0.026 inch) between the fixed SAS and the throttle lever.
3. When using scan tool, MB991502, turn the ignition switch "ON." (Do not start engine.) Observe operation of the closed throttle position switch.
4. Loosen the throttle p05ition sensor mounting bolts. Turn the throttle position sensor body fully clockwise.
5. In this condition, make sure that the closed throttle position switch is "ON."
6. Slowly turn the throttle position sensor counterclockwise until the closed throttle position switch is turns "OFF". Tighten the throttle position
sensor installation bolt at that position. When using the scan tool, proceed to Step 8.
7. When not using scan tool, MB991502, proceed as follows:
(1) Connect special tool, MB991348, between the throttle position sensor connectors which have been disconnected. (Connect all terminals taking
care not to mistake the terminal number.)