Montero Sport 2WD V6-3.0L SOHC (1997)
3. Place three old tires without wheels on top of the tire secured to the air bag module.
Air Bag Module (front Passenger's Side)
1. Connect the deployment wires to special tool MB686560, pass it beneath the tire and wheel assembly, and connect it to the air bag module.
CAUTION:
-
Leave some space below the wheel for the deployment wires.
If there is no space, the reaction of the air bag deployment could result in damage of the adaptor harness.
-
During deployment, the connector of special tool MB68656O must not be between the tires.
2. Pass the thick wires into the hole of the air bag module bracket, and secure it to the wheel of the old tire with wheel (four locations), with the
air bag facing upwards.
3. Place three old tires without wheels on top of the tire secured to the air bag module, and secure all tires together with ropes (four locations).
WARNING:
-
Before deployment, check carefully to be sure that no one is nearby.
-
The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before attempting to
handle it. Although not poisonous, do not inhale gas from air bag deployment. See Deployed Air Bag Module Disposal Procedures for
post-deployment handling instructions.
