Montero Sport 2WD V6-3.0L SOHC (1997)
Clockspring Assembly / Spiral Cable: Service and Repair
WARNING:
-
Never attempt to disassemble or repair the air bag modules or clock spring. If faulty, replace it.
-
Do not drop the air bag modules or clock spring or allow contact with water, grease or oil.
Replace it if a dent, crack, deformation or rust is detected.
-
The air bag modules should be stored on a flat surface and placed so that the pad surface is facing upward.
Do not place anything on top of it.
-
Do not expose the air bag modules to temperatures over 93° C (200° F).
-
After deployment of an air bag, replace the clock spring with a new one.
-
Wear gloves and safety glasses when handling air bags that have already deployed.
-
An undeployed air bag module should only be disposed of in accordance with the procedures
REMOVAL AND INSTALLATION
Removal And Installation
Air Bag Module (Driver's Side), Clock Spring
Pre-Removal Operation
After setting the steering wheel and the front wheels to the straight ahead position, remove the ignition key.
Air Bag Module Removal Steps
-
Post-installation Inspection
1. Negative (-) Battery Cable Connection
2. Air Bag Module
-
Pre-installation Inspection
Clock Spring Removal Steps
-
Post-installation Inspection
1. Negative (-) Battery Cable Connection
2. Air Bag Module
3. Steering Wheel
