Montero Sport 2WD V6-3.0L SOHC (1997)
WARNING: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and deployment.
Pre-Installation Inspection
To mount the new front impact sensor, visually check it and measure the resistance between the terminals. (Refer to the previous item
"INSPECTION")
Step 2: Front Impact Sensor Installation
WARNING: The SRS may not activate properly if a front impact sensor is not installed properly, which could result in serious injury or
death to the vehicle's driver.
1. Securely connect the connector.
2. Position the front impact sensor facing toward the front of the vehicle as shown by the arrow on the label, and install it securely.
Post-installation Inspection
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then remain off for at least five seconds after turning "OFF?"
4. If yes, the SRS system is functioning properly. If no, Refer to SRS Diagnosis.
INSPECTION
WARNING: If a dent, crack, deformation or rust is detected, replace with a new sensor.
1. Check the front impact sensor for dents, cracks, deformation or rust.
WARNING: Always replace the sensor with a new one if the resistance is not within the standard value.
