Montero Sport ES 2WD V6-3.0L SOHC (2001)
Throttle Full Close Switch: Adjustments
CLOSED THROTTLE POSITION SWITCH AND THROTTLE POSITION SENSOR ADJUSTMENT
Required Special Tools:
MB991502: Scan Tool (MUT-II)
MB991348: Test Harness Set
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector. When not using the scan tool MB991502, proceed as follows.
1. Disconnect the throttle position sensor connector.
2. Connect the ohmmeter between terminals 2 (closed throttle position switch) and 1 (sensor ground) by using jumper wire.
2. Insert a feeler gauge as follows:
<Vehicles without auto-cruise control system>
Insert a feeler gauge with a thickness of 0.65 mm (0.026 inch) between the fixed SAS and the throttle lever.
