Montero Sport ES 4WD V6-3.0L SOHC (2002)
EGR Control Solenoid: Testing and Inspection
EGR SOLENOID CHECK
1. Disconnect the vacuum hose (black, yellow stripe) from the EGR solenoid.
NOTE: When disconnecting the vacuum hose, always make sure that it can be reconnected at its original position.
2. Disconnect the harness connector.
3. Connect a hand vacuum pump to the nipple (A) of the EGR solenoid. (Refer to the illustration at left.)
4. Check airtightness by applying a vacuum with voltage applied directly from the battery to the EGR solenoid and without applying voltage.
5. Measure the resistance between the terminals of the EGR solenoid.
Standard value: 29 - 35 Ohm [at 20 °C (68 °F)]
6. Replace solenoid if resistance is out of specification.
