Montero Sport ES 4WD V6-3.0L SOHC (2002)
Transmission Cooler: Testing and Inspection
OIL COOLER FLOW CHECK
After the new or repaired transmission has been installed, fill to the proper level with DIAMOND ATF SP III or equivalent A/T fluid. The flow should
be checked using the following procedure:
CAUTION: With the fluid set at the proper level, A/T fluid collection should not exceed one quart or internal damage to the transmission may occur.
1. Disconnect the OUTLET (From cooler) line at the transmission and place a collecting container under the disconnected line.
2. Run the engine at curb idle speed with the shift selector in neutral.
3. If A/T fluid flow is intermittent or it takes more than 20 seconds to collect one quart of A/T fluid, replace the cooler.
4. If flow is found to be within acceptable limits, reconnect the cooler line. Then fill the transmission to the proper level, using DIAMOND ATF SP
III or equivalent fluid.