mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Radio and Tape Player Replacement|Page 5818 > < Radio and Tape Player Replacement
Page 1
background image

Radio/Stereo: Service and Repair
Input of Security Code For Radio and Tape Player W/Anti-Theft

The radio and tape player does not work under the following conditions.

-

Power supply to the radio and tape player has been suspended for more than an hour continuously by removing the cable from the battery terminal
or disconnecting the harness connectors.

-

The power supply to the radio and tape player has been suspended for more than an hour due to a blown fuse or discharged battery.

-

The radio and tape player has been replaced.

If the radio and tape player does not work for these conditions enter the security code as follows.

NOTE:  Tape player displays "CODE or "0FF," CD player displays "CODE" or "OFF"

1. Confirm the security code using any of the following methods.

1. Use the security code indicated on the cards retained by the car.

2. If the security code is unknown owing to the user's loss of the card:

a. Remove the radio and tape player, referring to R54-164.
B. Read the serial number stamped on the radio and tape player.
C. Look up the security code (anti-theft code table) corresponding to the serial number.

3. When the radio and tape player is replaced: Use the security code on the cards attached to the upper surface of the replacement radio and tape

player.

NOTE: Deliver the two cards to the user.

Radio and Tape Player Replacement|Page 5818 > < Radio and Tape Player Replacement