mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 4466 > < Initial Inspection and Diagnostic Overview|Page 4464
Page 7
background image

Check that the malfunction is eliminated.

If harness connector D-16 is in good condition, go to Step 10.

STEP 10. Check the harness wires between fusible link number 6 and key reminder switch connector D-16.

If the harness wires between fusible link number 6 and key reminder switch D-16 are damaged, repair them. Check that the malfunction is eliminated.
If the harness wires are in good condition, go to Step 11.

NOTE:  After inspecting joint connector (1)C-11, junction block connectors D-14, D-01 and IOD or storage connector A-54X, inspect the wire. If the
joint connector  1 . C-11, junction block connectors D-14, D-01 and IOD or storage connector A-54X are damaged, repair or replace them.

Initial Inspection and Diagnostic Overview|Page 4466 > < Initial Inspection and Diagnostic Overview|Page 4464