Montero Sport XLS 4WD V6-3.0L SOHC (1999)
STEP 6. Check the harness wires between the driver's side door switch connector E-33 and ETACS-ECU connector D-11 or tone alarm-ECU
D-12.
If the harness wires between the driver's side door switch connector E-33 and ETACS-ECU (or tone alarm-ECU) connector D-11 (or D-12) are
damaged, repair them. Check that the malfunction is eliminated.
If the harness wires are in good condition, replace the ETACS-ECU or tone alarm-ECU. Check that the malfunction is eliminated.
NOTE: After inspecting the junction block connector D-14 and intermediate connector E-42; inspect the wire. If the junction block connector D-14 and
intermediate connector E-24 are damaged, repair or replace them.
Inspection Procedure 3
The Ignition Key Hole Illumination Light Does Not Go Out When the Ignition Key Is Turned to the "ON" Position. (However, It Goes Out
After 15 Seconds.)
The Ignition Key Reminder Tone Alarm Does Not Stop Sounding When the Ignition Key Is Turned to the "ON" Position. The Tone Alarm
Stops Sounding By Closing the Driver's Door.)
Ignition Key Hole Illumination Light Circuit
CIRCUIT OPERATION
Refer to Ignition Switch for the circuit operations other than those below.
When the driver's door is opened without removing the ignition key, the tone alarm will sound intermittently to remind that the ignition key has not been
removed.
TECHNICAL DESCRIPTION (COMMENT)
The input signal from the ignition switch may be defective, or the ETACS-ECU or tone alarm-ECU may be defective. If the multi-purpose fuse is blown,
the harness may be short circuited.
TROUBLESHOOTING HINTS
-
Malfunction of the fuse
-
Malfunction of the connector
-
Damaged harness wire
-
Malfunction of the ETACS-ECU or tone alarm-ECU
DIAGNOSIS
Required Special Tool <Vehicles with ETACS-ECU>:
MB991502: Scan Tool (MUT-II)
STEP 1. Check the input signal from the ignition switch.
<Vehicles with ETACS-ECU>
CAUTION: To prevent damage to scan tool MB991502, make sure the ignition switch is "OFF" before connecting or disconnecting it.
