Montero Sport XLS 4WD V6-3.0L SOHC (1999)
CAUTION: The outer end of the tie rod end has a left thread.
1. Install the tie rod assembly so that the dimension is as shown in the illustration.
NOTE: The illustration at left shows the left side tie rod assembly. The right side tie rod assembly is symmetrical to the left side assembly.
2. Adjust the pipe so that the difference between dimensions (a) and (b) is 1.5 mm (0.059 inch) or less, and then temporarily tighten the lock nut.
NOTE: Fully tighten the lock nut after the tie rod assembly is installed to the body and the toe-in has been adjusted.
INSPECTION
-
Check the rubber parts for cracks and break.
Dust Cover Check
1. Press the dust cover with a finger to check whether the dust cover is cracked or damaged.
2. If there are any cracks in or damage to the dust cover, replace the tie rod end assembly or idler arm.
NOTE: Cracked or damaged dust cover may cause damage to the ball joint. In addition, if the dust cover is damaged during service work,
replace the dust cover.
DISASSEMBLY AND ASSEMBLY
Assembly Service Points
>A< Tie Rod End Installation
