Montero Sport XLS 4WD V6-3.5L SOHC (2002)
3. Measure the voltage between terminal number 3 and ground.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Replace the ETACS-ECU. Check that the malfunction is eliminated.
NO: Go to Step 4.
STEP 4. Check the ETACS-ECU connector D-11 for damage.
Q: Is the ETACS-ECU connector D-11 in good condition?
YES: Go to Step 5.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 5. Check the harness wires between the ignition switch (IG1) and ETACS-ECU connector D-11.
NOTE: After inspecting junction block D-08, inspect the wire. If junction block D-08 is damaged, repair or replace it. Refer to Harness Connector
Inspection.
Q: Are the harness wire between the ignition switch (IG1) and ETACS-ECU connector D-11 in good condition?
YES: Go to Step 6.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 6. Recheck for malfunction.
Q: Is a malfunction eliminated?
YES: This diagnosis is complete. (If no malfunctions are not found in all steps, an intermittent malfunction is suspected. Refer to How to Use
Troubleshooting/Inspection Service Point - How to Cope with Intermittent Malfunction.)
NO: Go to Step 1.