Montero Sport XS 2WD V6-3.5L SOHC (2001)
Wheel Cylinder: Testing and Inspection
REAR DRUM BRAKE LININGS AND REAR WHEEL CYLINDERS (INSPECT FOR WEAR AND LEAKS)
1. Remove the brake drum and check the thickness of brake shoe lining for wear. Check the automatic brake adjusting system by hand to see if it
operates smoothly.
Also see if the gears are in proper mesh with each other. To assure smooth operation apply a very thin coat of multipurpose grease to the friction
surface of the adjuster and link shaft.
CAUTION: Never split or Intermix brake shoe sets. All four shoes must be replaced as a complete set.
2. Inspect the wheel cylinder boot for evidence of a brake fluid leak. Visually check the boot for cuts, tears or heat cracks. (a slight amount of fluid
on the boot may not be a leak, but may be preservative fluid used at assembly.) Checking the Brake Shoes for Wear
Thickness of lining (A)
Minimum limit: 1.0 mm (0.04 inch)
