Montero Sport XS 2WD V6-3.5L SOHC (2001)
2. Air bag module (font passenger's side)
a. Connect the deployment wires to special tool MB686560, pass it beneath the tire and wheel assembly, and connect it to the air bag module.
CAUTION:
-
The adapter harness below the wheel should be loose. If it is too tight, the reaction when the air bag deploys could damage the adapter
harness.
-
During deployment, the connector of special tool MB686560 must not be between the tires.
b. Pass the thick wires into the hole of the air bag module bracket, and secure it to the wheel of the old tire with wheel (four locations), with
the air bag facing upwards.
c. Place three old tires without wheels on top of the tire secured to the air bag module, and secure all tires together with ropes (four
locations).
3. Seat belt pre-tensioner
a. Connect special tool MB686560, which the deployment wires is attached to, to the seat belt pre-tensioner connector.
CAUTION: The adapter harness below the wheel should be loose. If it is too tight, the reaction when the air bag deploys could damage the
adapter harness.
b. Pass the thick wires through the hole on the seat belt pre-tensioner bracket and secure them to the front (raised part) of the wheel on two
places.
