Montero SR 4WD V6-3.5L SOHC (1997)
-
Ensure the sensors' output voltage is within specifications. See: Testing and Inspection
-
Insert a feeler gage into the space between the speed sensors' pole piece and the rotors' toothed surface, and check to be sure that the clearance
at all points is within the standard value. The standard value is 0.2-1.0 mm (0.008-0.039 inch.)
NOTE: If the clearance between the speed sensor pole piece and the rotor toothed surface is not within the standard value range, it is probable
that the rotor is incorrectly installed, so re-check installation.
REAR REPLACEMENT
1. Remove the band.
2. Remove the rear speed sensor.
CAUTION: Be careful when handling the pole piece at the tip of the speed sensor and the toothed edge of the rotor so as not to damage them by
striking against other parts.
3. Remove the O-ring and clip.
4. Remove the rear rotor. Refer to "Transmission and Drivetrain."
5. Reverse procedure to install, ensuring the sensors' output voltage is within specifications. See: Testing and Inspection
