mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Relays and Modules - Starting and Charging > < SRS - Diagnostic Trouble Code (DTC) Erasure|Page 196
Page 2
background image

Step 5: SRS Air Bag Control Unit (SRS-ECU) Installation

CAUTION:  The SRS may not activate if SRS-ECU is not installed properly, which could result in the SRS system not operating properly in a
collision.

POST INSTALLATION INSPECTION

Reconnect the negative battery terminal. Turn the ignition key to the "ON" position. Does the "SRS" warning light illuminated for about 7 seconds
, turn off and then remain off for at least 45 seconds? If yes, SRS system is functioning properly. If no, consult SRS Warning Light Inspection.

INSPECTION

-

Check the SRS-ECU case and brackets for dents, cracks or deformities.

-

Check connectors and lock lever for damage, and terminals for deformities.

CAUTION:  If a dent, cracks, deformation or rust is discovered, replace the SRS-ECU with a new one.

NOTE:  For checking of the SRS-ECU other than described above, refer to the section concerning troubleshooting. 

Relays and Modules - Starting and Charging > < SRS - Diagnostic Trouble Code (DTC) Erasure|Page 196