Montero SR 4WD V6-3.5L SOHC (1997)
C. Snap ring installation. (19)
CAUTION: Be sure the end gap of the snap ring is not aligned with the stopper of the spring seat.
1. After the snap ring is installed, check the operation of the first & reverse brake piston as follows:
2. By applying compressed air (400-800 kPa, 57-113 psi) into the oil hole of the transmission case as illustrated, check that the first &
reverse brake piston slides smoothly.
D. Thrust bearing with race installation. (18)
1. Apply petrolatum to the thrust bearing with race and attach it so that the race side is oriented to the transmission case side.
E. Thrust race / thrust bearing / thrust race installation. (12, 13 & 14)
1. Apply petrolatum to the thrust bearing, thrust race [28.8 mm (1.13 inch) in inner diameter] and thrust race [27.6 mm (1.09 inch) in inner
diameter] and attach them to the rear planetary ring gear in the illustrated order and direction.
F. Planetary carrier thrust washers No. 1 and No. 2 installation. (9 & 10)
