Montero XLS 4WD V6-3.5L SOHC (2001)
![background image](/mitsubishi/montero_xls_4wd/v6-3.5l_sohc/Page-1640002.png)
Checking Connection of System
The RV-Meter is reset by using the following "system-connection-check" procedures. Use this procedure to reset the meter when the connection
information is lost, when you encounter ANY display errors, or when ANY RV-meter information fails to display.
1.
With the key in the OFF position, push and hold the "DISP" button.
2.
While continuing to hold down the "DISP" button, turn the ignition switch to ACC position. Keep holding the "DISP" button until you hear a beep
tone which will last for about 10 seconds. You should then see the display shown.
3.
As instructed in the display in step 2, turn the ignition key to the ON position to start the system-connection - check.
4.
Wait for approximately 8-seconds. The system will give a beep signal. When the connection is completed, this message will display.
NOTE:
After resetting the RV-meter it will be necessary to reset the compass. Use the following compass resetting procedures.
INCORRECT COMPASS DISPLAY
A.
Compass Calibration
The compass will usually adjust automatically when the vehicle is moving. However the compass may at times require manual intervention. If this
occurs, the RV-Meter will display the "Need to calibrate the compass" message. Follow the instructions below to calibrate the compass.