mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 4175 > < Initial Inspection and Diagnostic Overview|Page 4173
Page 7
background image

NOTE:   After inspecting intermediate connector E-111, inspect the wire. If intermediate connector E-111 is damaged, repair or replace it. If the
connector has been repaired or replaced, go to Step 4.

Q: Is the harness wire between combination meter connector D-3 and the ABS-ECU connector E-106 damaged?

YES: Repair it and then go to Step 4.
NO: Replace the combination meter and then go to Step 4.

STEP 4. Check symptoms
Q:
 Does the ABS warning light turn off 3 seconds after start-up?

YES: This diagnosis is complete.
NO: Start over at Step 1.

Inspection Procedure 3: the Buzzer Does Not Sound

INSPECTION PROCEDURE 3: The buzzer does not sound. 

Buzzer Circuit

Part 1 of 2 

Initial Inspection and Diagnostic Overview|Page 4175 > < Initial Inspection and Diagnostic Overview|Page 4173