Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connector D-125 and junction block connector D-217; check the wires. If intermediate connector D-125 and
junction block connector D-217 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between rear door switch (LH) connector F-09 and ETACS-ECU connector D-222 in good condition?
YES: Replace the ETACS-ECU. The rear door switch (LH) input signal should be able to be checked and the functions, which are described in the
"Technical Description (comment)," should work normally.
NO: Repair them. The rear door switch (LH) input signal should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
STEP 10. Check rear door switch (RH) connector F-05 and ETACS-ECU connector D-222 for damage.
Q: Are rear door switch (RH) connector F-05 and ETACS-ECU connector D-222 in good condition?
YES: Go to Step 11.
NO: Repair or replace them. Refer to Harness Connector Inspection. The rear door switch (RH) input signal should be able to be checked and the
functions, which are described in the "Technical Description (comment)," should work normally.
