Montero XLS 4WD V6-3.5L SOHC (2001)
NOTE: After checking intermediate connector D-125 and junction block connector D-217, check the wires. If intermediate connector D-125 and
junction block connector D-217 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between back door switch connector G-15 and ETACS-ECU connector D-222 in good condition?
YES: Replace the ETACS-ECU. The back door switch input signal should be able to be checked and the functions, which are described in the
"Technical Description (comment)," should work normally.
NO: Repair them. The back door switch input signal should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
Inspection Procedure Q-10
The driver's, passenger's or back door lock key cylinder switch is not sent to the ETACS-ECU