mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2280 > < Initial Inspection and Diagnostic Overview|Page 2278
Page 250
background image

1. Windshield intermittent wiper interval adjusting knob check. Check the resistance at terminal numbers 3 and 6. The resistance should change

smoothly from approximately 0 ohm ("FAST" position) to approximately 1 kohms ("SLOW" position).

2. Switch body check

Q: Is the windshield intermittent wiper interval adjusting knob and switch body in good condition?

YES: Go to Step 2.
NO: Replace it. Check that the input signal from the windshield intermittent wiper interval adjusting knob can be checked and the wiper interval can
be adjusted.

Initial Inspection and Diagnostic Overview|Page 2280 > < Initial Inspection and Diagnostic Overview|Page 2278