Montero XLS 4WD V6-3.5L SOHC (2001)
If the tie rod end is disengaged from the knuckle, renew the tie rod end dust cover and retainer by following the procedure below.
1. Unclip the spring ring to remove the dust cover.
CAUTION
Be careful not to damage the ball joint stud.
2. Use a flat-tipped screwdriver to remove the retainer.
3. Apply multi-purpose grease to the new retainer, and assemble it to the new dust cover.
4. Fill multi-purpose grease inside the dust cover as shown.
Amount to use: 4 +/-1 g (0.14 +/-0.04 oz)
5. Apply multi-purpose grease to the dust cover lip.
6. Tape the stud threads to avoid damage.
CAUTION
Ensure grease does not come into contact with the ball joint threads and tapers.Wipe off the grease if contaminated.
7. Install the ball joint to the dust cover.
8. Secure the dust cover with the clip ring.
9. Engage the tie rod end ball joint with the knuckle.