Outlander 2WD L4-2.4L (4B12) (2008)
13. Apply a 4 mm bead of liquid gasket as illustrated.
Specified sealant: THREE BOND 1217G or exact equivalent
14. Install the cylinder head cover and tighten the tightening bolts using the following procedures.
1) Temporarily tighten to the following torque in order shown in the illustration.
Tightening torque: 3.0 ± 1.0 Nm (27 ± 9 in-lb)
2) Tighten to the specified torque in order shown in the illustration.
Specified torque: 5.5 ± 0.5 Nm (49 ± 9 in-lb)
15. Install the ignition coils.
[3.0L Engine]
NOTE: Perform the valve clearance check and adjustment at the engine cold state.
1. Remove all of the ignition coils.
2. Remove the rocker cover.