Outlander 2WD L4-24L (4B12) (2008) Information Bus Component Inspection
3. Measure the voltage between joint connector (CAN2) terminal 6 and body ground.
OK: 4.7 volts or less
4. Measure the voltage between joint connector (CAN2) terminal 19 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES <vehicles with ASC> : Go to Step 2.
YES <vehicles without ASC (2WD) > : Go to Step 4.
YES <vehicles without ASC (4WD) > : Go to Step 3.
NO : Go to Step 9.
STEP 2. Check the wiring harness between joint connector (CAN2) C-04 and steering wheel sensor connector C-209 for a short to power
supply. Measure the voltage at joint connector (CAN2) C-04.
CAUTION:
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (CAN2), and measure the voltage at the wiring harness side of joint connector (CAN2).
2. Turn the ignition switch to the ON position.