Outlander 2WD V6-3.0L (6B31) (2007)
NO: The wiring harness may be damaged or the connector (s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Check that the input signal of front door switch (LH) is normal.
Inspection Procedure 8
Inspection Procedure 8: ETACS-ECU does not receive any signal from the rear door switch (RH).
Rear Door Switch (RH) Input Circuit
TECHNICAL DESCRIPTION (COMMENT)
If there is an error to the rear door switch (RH) input signal, the rear door switch (RH) signal is no longer output to the communication line.
TROUBLESHOOTING HINTS
-
The rear door switch (RH) may be defective
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set