Outlander 2WD V6-3.0L (6B31) (2007)
/Page-393011.png)
CAUTION:
^
Never re-use the O-ring.
^
Before installing O-ring, wind sealing tape around the oil passages cut-out area of engine oil control valve, to prevent damage. If the
O-ring is damaged, it can cause an oil leak.
1. Apply a small amount of engine oil to the O-ring and then install it to the engine oil control valve.
2. Install the engine oil control valve to the cylinder head.
3. Tighten the engine oil control valve.
Tightening torque: 11 ± 1 Nm (98 ± 8 in-lb)
