Outlander 2WD V6-3.0L (6B31) (2007)
/Page-1772002.png)
STEP 2. Using scan tool MB991958, read the diagnostic trouble code.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect scan tool MB991958. Refer to "How to connect scan too (M.U.T.-III)."
2. Turn the ignition switch to the "ON" position.
3. Check whether the ETACS-ECU related DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the DTC set?
YES: Diagnose the ETACS-ECU. Refer to Body Control Systems, Diagnosis.
NO: Go to Step 3.
STEP 3. Using scan tool MB991958, check data list.
Use the ETACS-ECU data list to check the signals related to the taillight illumination.
-
Turn the ignition switch to the "ACC" position.
-
Turn the taillight switch to the "ON" position.
Q: Does scan tool MB991958 display the items "Tail light" as normal condition?
YES<Normal condition is displayed for item.>: Go to Step 4.
NO<Normal condition is not displayed for item No.218.>: Troubleshoot the ETACS-ECU. Refer to Body Control Systems, Diagnosis -
Inspection Procedure 12 "ETACS-ECU does not receive any signal from the column switch signal".
STEP 4. Retest the system
Check that the taillight illuminates normally.
Q: Does the taillight work normally?
YES: The trouble can be an intermittent malfunction (Refer to How to use Troubleshooting/ inspection Service Points - How to Cope with
