Outlander 2WD V6-3.0L (6B31) (2007)
Removal steps 8-9
Required Special Tools:
*
MB990767: End Yoke Holder
*
MD998716: Crankshaft Wrench
*
MD998719: Pin
REMOVAL SERVICE POINTS
<<A>> DRIVE BELT AUTO-TENSIONER/GENERATOR DRIVE BELT REMOVAL
CAUTION: When the generator drive belt is reused, draw an arrow indicating the rotating direction on the back of the belt using chalk to
install the same direction.
1. Turn the drive belt auto-tensioner to counterclockwise, and insert the L-shaped hexagon wrench to the auto-tensioner hole in order to fix the
auto-tensioner.
2. Remove the generator drive belt.
3. Remove the drive belt auto-tensioner.
<<B>> CRANKSHAFT PULLEY REMOVAL
CAUTION: Use only the specified special tools, or a damaged pulley damper could result.
Use special tools MB990767 and MD998719 to remove the crankshaft pulley from the crankshaft.
<<C>> TIMING BELT AUTO-TENSIONER REMOVAL