Outlander 2WD V6-3.0L (6B31) (2007)
[[B]] COVER REMOVAL
Insert the ornament remover (Special tool: MB990784) into the notch shown in the figure, and remove the cover.
[[C]] DRIVER'S AIR BAG MODULE CONNECTOR REMOVAL
Slide the outer housing of the driver's air bag module connector in the arrow direction shown, and disconnect the connector.
[[D]] AIR BAG MODULE ASSEMBLY REMOVAL
WARNING:
-
The air bag module must not be measured with such equipment as an ohmmeter.
-
The air bag module must not be disassembled.
-
The removed air bag module should be stored in a clean, dry place with the deployment surface facing up.
Loosen the torx screw and remove the air bag module assembly.