Outlander 2WD V6-3.0L (6B31) (2007)
[[E]] STEERING WHEEL ASSEMBLY REMOVAL
Use special tool MB990803 to remove the steering wheel.
[[F]] CLOCK SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean, dry place.
[[G]] PASSENGER'S (FRONT) AIR BAG MODULE CONNECTOR REMOVAL
Slide the outer housing of the passenger's (front) air bag module connector in the arrow direction shown, and disconnect the connector.
[[H]] PASSENGER'S (FRONT) AIR BAG MODULE REMOVAL
WARNING:
-
The air bag module must not be measured with such equipment as an ohmmeter.
-
The air bag module must not be disassembled.
-
The removed air bag module should be stored in a clean, dry place with the deployment surface facing up.
Insert a slotted (-) screwdriver or similar tool to the location shown in the figure. After disengaging the tabs, remove the front passenger's air bag module.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.
1. When installing the new air bag modules and clock spring refer to "INSPECTION".