Outlander 2WD V6-3.0L (6B31) (2007)
/Page-1387004.png)
SIDE IMPACT SENSOR
1. Check that there is no bending or corrosion in the center pillar and quarter panel.
2. Check that there is no denting, breakage or bending of the side impact sensor.
3. Check that there is no harness crimping, connector damage or bent terminals.
NOTE: The illustration shows the side impact sensor (RH). The position of the side impact sensor (LH) is symmetrical to this.
SEAT SLIDE SENSOR
1. Check that there is no connector damage, bent terminals or harness crimping.
2. Check the installation of the seat slide sensor.
