Outlander 2WD V6-3.0L (6B31) (2007)
4. Remove the stop lamp switch by rotating it counterclockwise 1/8 of a turn.
5. Disconnect the electrical connector from the stop lamp switch.
CAUTION
DO NOT REMOVE OR DAMAGE THE SWITCH RETAINER (PEDAL CLIP).
IT IS NOT REUSABLE AND MUST BE REPLACED IF REMOVED.
CAUTION
WEAR SAFETY GLASSES WHEN SPRAYING PARTS CLEANER.
Cleaning the connector and the pedal pad requires the use of a specific Mitsubishi approved parts cleaner. Use only the part number listed below during
this recall procedure.
^
A999ZC1X03C Brake Parts Cleaner, Non-chlorinated.
CAUTION
DO NOT USE A CHLORINATED PARTS CLEANER. CHLORINATED PARTS CLEANERS MAY HAVE AN ADVERSE AFFECT ON PLASTIC
COMPONENTS (CONNECTOR, WIRING HARNESS, ETC.).
CAUTION
USING A RAG, COMPLETELY COVER THE WIRING HARNESS TO PREVENT CONTACT WITH ANY PARTS CLEANER. THOROUGHLY
WIPE WITH A CLEAN, DRY CLOTH IMMEDIATELY AFTER SPRAYING.
NOTE:
When using parts cleaner during the following steps, use a rag to protect nearby surfaces.
6. Use aerosol parts cleaner to degrease the electrical connector contacts and body. Fit a straw attachment to the nozzle to control spray accuracy.
7. Wipe the sprayed components and general area dry using a clean rag. Then allow everything to air dry for at least one minute.
NOTE:
Use a new, clean rag for each step. A used rag can contaminate the connector.