Outlander 2WD V6-3.0L (6B31) (2007)
Alignment: Service and Repair
Rear Suspension
ON-VEHICLE SERVICE
REAR WHEEL ALIGNMENT CHECK AND ADJUSTMENT
1. Before the wheel alignment measurement, adjust the rear suspension, wheel, and tires in good condition.
2. Park the vehicle on a level surface to measure the wheel alignment.
TOE-IN
Standard value: 3 ± 2 mm (0.12 ± 0.08 inch)
If it is out of the standard range, adjust as follows:
Turn the toe adjusting bolt (the mounting bolt inside the body on the control link) to adjust.
Left wheels: Clockwise -> (+) Toe in
Right wheels: Clockwise -> (-) Toe in
Toe-in varies approximately 2.6 mm (0.10 inch) (equivalent to 0°16' of the toe angle for one side) for each scale mark.
CAMBER
Standard value: -0°25' ± 0°30' (left/right difference 0°30' max)
NOTE:
^
For FWD vehicles with aluminum wheels, attach the camber/caster/kingpin gauge by using a compensator.
^
For AWD vehicles with aluminum wheels, tighten the wheel alignment gauge attachment (Special tool: MB991004) to the specified torque, then
measure the camber.
^
The camber is pre-adjusted at factory and is not adjustable.